MIL-PRF-19500/385H
3. REQUIREMENTS
3.1 General. The individual item requirements shall be as specified in MIL-PRF-19500 and as modified herein.
3.2 Qualification. Devices furnished under this specification shall be products that are manufactured by a
manufacturer authorized by the qualifying activity for listing on the applicable qualified manufacturer's list (QML)
before contract award (see 4.2 and 6.3).
3.3 Abbreviations, symbols, and definitions. Abbreviations, symbols, and definitions used herein shall be as
specified in MIL-PRF-19500.
3.4 Interface and physical dimensions. The interface and physical dimensions shall be as specified in
MIL-PRF-19500 and on figures 1 and 2.
3.4.1 Lead finish. Unless otherwise specified, lead finish shall be solderable in accordance with MIL-PRF-19500,
MIL-STD-750, and herein. Where a choice of lead finish is desired, it shall be specified in the acquisition document
(see 6.2).
3.5 Electrostatic discharge protection. The devices covered by this specification require electrostatic discharge
protection.
3.5.1 Handling. Metal oxide semiconductor (MOS) devices must be handled with certain precautions to avoid
damage due to the accumulation of static charge. However, the following handling practices are recommended
(see 3.5).
a.
Devices should be handled on benches with conductive handling devices.
b.
Ground test equipment, tools, and personnel handling devices.
c.
Do not handle devices by the leads.
d.
Store devices in conductive foam or carriers.
e.
Avoid use of plastic, rubber or silk in MOS areas.
f.
Maintain relative humidity above 50 percent if practical.
g.
Care should be exercised during test and troubleshooting to apply not more than maximum rated
voltage to any lead.
Gate must be terminated to source, R or 100 k, whenever bias voltage is applied drain to source.
h.
3.6 Electrical performance characteristics. Unless otherwise specified herein, the electrical performance
characteristics are as specified in 1.3, 1.4, and table I.
3.7 Electrical test requirements. The electrical test requirements shall be as specified in table I.
3.8 Marking. Marking shall be in accordance with MIL-PRF-19500 except for the UB suffix package. Marking on
the UB package shall consist of an abbreviated part number, the date code, and the manufacturer's symbol or logo.
The prefixes JAN, JANTX, JANTXV, and JANS can be abbreviated as J, JX, JV, and JS respectively.
3.9 Workmanship. Semiconductor devices shall be processed in such a manner as to be uniform in quality and
shall be free from other defects that will affect life, serviceability, or appearance.
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business