MIL-PRF-19500P
6.2 Acquisition requirements. Acquisition documents should specify the following:
a.
Title, number, and date of this specification.
b.
Packaging requirements (see 5.1).
c.
PIN (see 1.3).
d.
Number of the applicable specification sheets (see 3.1). For additional information on PINs, contact DLA
Land and Maritime, ATTN: VAC, P.O. Box 3990, Columbus, OH 43218-3990, or
e.
Lead formation, length, finish, if other than that specified, or when a choice is required by the device
application.
f.
Data requirements, when applicable.
g.
Specify point of shipment.
h.
PIND screening when required.
i.
Date code and specification revision letter should not be restricted by the acquisition documents (see
3.10.8).
6.2.1 Order requirements. The date code and specification revision letter should not be restricted by the
acquisition documents (see 3.10.8). The JAN brand or the abbreviations (see 3.10.6.1) must not be used on any
semiconductor device acquired under contracts which permit or require any changes to this specification or the
applicable specification sheet, except for:
a.
Lead length.
b.
Lead finish.
c.
PIND testing. PIND screening to requirements beyond those specified herein may be performed only when
imposed by the acquisition document upon the component manufacturer. A new PIN will be created in
accordance with 1.3 and 3.10.3. Devices which pass such screens may be JAN branded or may retain the
JAN brand if already marked. All devices failing such screens must not be JAN branded or, if already
marked, must have the JAN brand removed or the device destroyed. PIND screening will follow the flow
outlined in Figure E-4 unless otherwise specified by the customer.
d.
Lead forming (see E.5.3.4 and E.5.4.2). The forming of leads must not be performed except for specific
customer orders where the lot is controlled throughout processing by specific lot travelers. The bend must
not be closer than .050 inch (1.27 mm) to the lead to package seal.
e.
Additional marking.
6.3 Qualification. With respect to products requiring qualification, awards will be made only for products which are,
at the time of award of a contract, qualified for inclusion in the Qualified Manufacturers List (QML), whether or not
such products have actually been so listed by that date. The attention of the contractors is called to these
requirements, and manufacturers are urged to arrange to have the products that they propose to offer to the Federal
Government tested for qualification in order that they may be eligible to be awarded contracts or orders for the
products covered by this specification. See the "Certification and Qualification Information for Manufacturers" booklet
(DLA Land and Maritime-VQE-19500) for details on the certification and qualification program. Information pertaining
to qualification of products may be obtained from DLA Land and Maritime, ATTN: VQE, P.O. Box 3990, Columbus,
OH 43218-3990 or e-mail vqe.chief@dla.mil. An online listing of products qualified to this specification may be found
in the Qualified Products Database (QPD) at https://assist.daps.dla.mil.
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business